衢州市质达商贸有限公司

Features: PART II

1, PART 2 has superior heat resistance, and has nothing to do with the mold temperature, can play an anti rust effect (about 130 degrees C).

2, high safety, do not contain nitrite dicyclohexyl ammonium nitrate and nitrite, almost no toxicity.

3, greatly reduce the mold preparation time. 3 injections (colorless) or 7 pre injection (colored), all of the rust inhibitor. Does not seep from the ejector pin and the slide block, does not make the molding product to be stained with the oil pollution.

4, two times to shorten the processing time, from the forming die first, 2 times of injection can be painted, printing, adhesive and two processing operations.

5, there is no impact on the plastic, in case the product dip BarrierGuard, its impact is little, do not have to worry about the dissolution of cracks, etc..

6, will not plug the pores. Even wrinkles, mirror processing of the mold, you can not clean, the effect is good; even for the injection molding of the mold, from the mold after the first injection will not be stained with oil.

Note: This product is colored and colorless products are colored products on the surface of the mold has a layer of green marks;

1、PART 2具有优越的耐热性，与模具温度无关，可发挥防锈效果(约130℃)。

2、安全性高，不含亚硝酸二环己基铵等亚硝酸盐和硝酸盐，几乎没有毒性。

3、大幅度减少模具的准备时间。3次注射（无色）或7次预注射(有色)，防锈剂全部气化。不会从喷射器销和滑块部位渗出，不会使成形品沾上油污。